Bracelet Sizing
-
Wrap a piece of string, floss, or a tape measurer around your wrist and note where the two ends meet using a pen or marker. Measure the length in inches, and add half an inch to to ensure the bracelet fits comfortably. This is your bracelet size.
-
Position your hand by tucking your thumb toward your palm as if you were sliding a bangle on. Wrap string, floss, or a tape measurer around the widest part of your hand, which is typically at or right below your knuckles. Mark where the material’s ends meet with a pen or marker. Measure the length of the material in inches to determine your bangle or cuff size. Subtract half an inch for a tighter fit.
-
Using a bracelet from your collection, measure the length of the bracelet, minus the clasp, in inches. This is your bracelet size.
Using a bangle or cuff from your collection, measure the internal diameter in inches with a ruler or tape measurer. Multiple the result by 3.14 to get your bangle size.
Ring Sizing
-
To determine your US ring size without using a ring, wrap thread or floss around the finger you’d like measured. Mark the material where it meets with its end using a pen or marker. Measure the length of the material from the end to your mark in millimeters using a ruler or tape measurer. Use the table below to determine your size.
-
You can measure your US ring size using an existing ring from your collection. Measure the internal diameter of the ring in millimeters using a ruler or tape measurer. Use the table below to determine your size.
